how to replace a cigarette lighter socket in a car

Best answer


Use a hook to reach the slots in the cigarette lighter. Look inside the cigarette lighter socket to find the small openings around its sides.Turn the lighter socket clockwise to loosen it. The socket rests inside a second metal tube on your vehicle.Pop off the dashboard panel if you can鈥檛 remove the socket. If the socket loosens but doesn鈥檛 pop out,pry off the panel around it.Unplug the wire connector if it is still attached to the socket. Lay the panel flat so you are able see any wires behind it.Pull and turn the socket as needed to finish removing it. Reach behind the panel to push the lighter socket toward you.

People also ask


  • How do you remove the back end of a cigarette lighter?

  • Use a socket wrench to remove the nut holding the lighter in place. Removing the connectors exposes the back end of the lighter socket. The nut is a metal ring with an opening in the center and it fits over the back end of the socket. The easiest way to remove it is by fitting a 1鈦?6 in (0.16 cm) socket wrench over it.

  • How to replace a lighter socket in a car?

  • To start, shut off the car and fuse to stop power from reaching the lighter. Then, you can get a socket out of the dashboard or the lower half of your vehicle by removing interior panels. Remove a lighter socket to replace it with a new one or an alternative to charge any device you need while driving.

  • What can you plug into a cigarette lighter socket?

  • Many useful accessories simply plug into the lighter socket. Vacuum cleaner (C), under-bonnet inspection light (D), dash-mounted cooling fan (E) and map reading light (F) can all be used in this way. Although you may not smoke, fitting a cigarette lighter inside your car could be more useful than you think.

  • Can you put a cigarette lighter in an old car?

  • Older cars, however, may not have a special hole ready to accept a cigarette lighter. In this case you will have to cut your own hole, either in the dashboard or in the centre console, fit the lighter socket and wire it up. You will find that there is a wide range of aftermarket cigarette lighters in car accessory shops.

    Leave a Reply

    Your email address will not be published. Required fields are marked *